discharge rate

英 [dɪsˈtʃɑːdʒ reɪt] 美 [dɪsˈtʃɑːrdʒ reɪt]

放电率;排气量;卸料速度

化学



双语例句

  1. The discharge rate of the steam boiler safety valves controls the ability to relieve the steam pressure in the abnormal situations.
    锅炉安全阀排放量的大小,决定了锅炉非正常情况下蒸汽压力的释放能力。
  2. Do not overheat cylinder to increase pressure or discharge rate.
    禁止使钢瓶过热来增加压力或流速。
  3. By increasing the discharge rate of the lymphatic glands, fat is swiftly and safely discharged.
    随着淋巴腺排泄比率的增加,脂肪很快地就能安全排泄。
  4. The relation of design flood peak discharge rate to collecting area in Nenjiang River basin was discussed in this paper.
    影响河流设计暴雨洪峰流量的自然地理因素较多,归纳起来主要有气候、暴雨、土质、土壤、植被及地形。
  5. This ship oil discharge monitoring and control system can measure signals of oil density, flow and ship speed by sensors and calculate instantaneous oil discharge rate and total oil discharged.
    所研制的排油监控系统能够通过传感器来测取油份浓度,流量和船速信号,并经计算机计算出油量瞬时排放率和排油总量。
  6. The technology improves the sand discharge rate and the sand pumping production rate.
    此技术提高了卸沙速度与抽沙生产率。
  7. More recently, the development is focused on enhancing the performance of the batteries at high discharge rate to meet the high demand of the new electric equipments.
    近来则集中在提高电池的高倍率放电性能,以满足新型电子设备的高功率要求,并简略地指出碱锰电池未来发展的方向。
  8. As a duster, 140 ha could be treated at the same discharge rate.
    作为一个除尘器,140医管局可以被视为在同一排放率。
  9. The reasons are that: the larger amplitude, the better the chip removal, the lower the short-circuit rate, the higher the discharge rate.
    但当振幅大于放电间隙时,硅与工具电极会产生直接撞击,火花放电机率下降。
  10. The discharge of industrial waste water is reduced and the discharge rate is low;
    工业废水排放量减少,排放达标率呈上升趋势;
  11. In this paper, Keeping discharge rate ( S) as the targer function, studies have been carried out on effects of the oil exit pore number ( N) and the radius of pore pitch ( R) on the viscous fingering phenomenon.
    以排出率(S)为目标函数,研究了出油孔数目(N)和孔距半径(R)对粘性指进的影响。
  12. The emitter discharge rate has remarkable effects on the ratio between horizontal and vertical wetting front.
    滴头流量对湿润体水平和垂向湿润距离的比值有显著的影响,滴头流量越大该值也越大,并且该值随着入渗时间的增加而逐渐变小。
  13. For the features of disc proportioning system's lag and discharge rate's fluctuation, applying time series analysis, a disc discharge rate prediction model based on AR model was set up.
    针对原料场圆盘配料系统下料量检测滞后和料量随堆料机进退变化较大的特点,应用时间序列分析方法建立了基于AR模型的圆盘下料量预测模型。
  14. The self-discharge rate increases with the increasing of ambient temperature;
    蓄电池的自放电率随环境温度的增大而增大;
  15. Increasing Discharge Rate and Controlling Water Cut for Water Flooding Oilfield
    注水开发油田提高采液量和稳油控水研究
  16. Initial discharge rate and inertia head calculation in lock filling and empty system
    船闸输水初始流量增率和惯性水头计算
  17. The results showed that charge rate has obvious influence on charge electrode potentials and charge efficiency and discharge rate has obvious effect on discharge performance;
    结果表明:在实验选择的充放制度下,充电倍率对贮氢电极的充电电位、充电效率及放电倍率对放电性能有明显的影响;
  18. When the discharge rate was less than 1 C, the material showed good discharge performance.
    当放电倍率小于1C时,材料表现出良好的放电性能。
  19. Factors affecting the electrochemical property of the hydrogen storage alloy: cycle number and charge/ discharge rate
    影响贮氢合金电化学性能测试结果的因素&循环次数和充放电制度
  20. Experiments have been done to verify the parameters such as the fire extinguishing time, discharge time, fire extinguishing concentration to obtain the flow coefficient and pressure as well as the discharge rate curve.
    通过具体试验验证灭火时间、喷射时间、灭火浓度等设计参数,获得了标准喷头的流量系数和压力与喷射率曲线,为系统设计确定喷头型号提供可靠依据;
  21. Increasing producing pressure differential and improving discharge rate are mainly used.
    其中放大生产压差、提高油田排液量是强化开采过程的主要方法。
  22. The soil has a relatively low hydraulic conductivity and relatively high diffusion rate. The irrigation model should take as "less time large amounts", and the emitter should take a small discharge rate and large emitter spacing.
    该类土导水率相对较低而扩散率相对较高,灌溉应采取少次多量的模式。灌水器应采用较小的滴头流量和较大的滴头间距。
  23. The result shows that complementary energy discharge rate of thermal-mechanical coupling damage increases with rise of temperature and time.
    计算表明,岩样损伤余能释放率随温度的升高和时间的延长而增大。
  24. Considering the effect of friction energy, we calculated the wellbore temperature field, and analyzed the effect of foam quality and discharge rate on fracture.
    在井筒温度场的计算中考虑了由摩擦产生的热量的影响。并分析了泡沫质量、排量等参数对裂缝尺寸的影响规律。